J. D. NEUHAUS Profi 025Ti, Руководство по эксплуатации

Страница: 59 / 218

The hoists Profi 025 TI to 2 TI are available with an
overload protection. Hoists for use within the EU are
equipped with this as standard from a carrying capacity
of 1 t and above.
A D J U S T I N G O V E R L OA D P RO T E C T I O N
The adjustment method described here is based on the
attachment of test loads.
DA N G E R !
If the overload protection is set too high,
impermissibly high stresses may arise if a
load exceeding the permissible load carrying
capacity is attached.
Attach overload of 125% of the load-carrying capacity.
If this overload is lifted, the adjusting bolt must be
adjusted clockwise until it is no longer possible to lift
the overload. If the overload is not lifted, the adjust-
ing bolt must be adjusted anticlockwise until it is
possible to lift the overload. Then it must be adjusted
back until it is no longer possible for it to lift the
overload.
After the adjustment process, it must be possible to
lift 110% of the nominal load. A dynamic overload
test of 110% of the nominal load is thus possible.
Adjusting overload protection
O V E R L OA D P RO T E C T I O N
powered by air !
M A I N T E N A NC E
Page 59
(+)
(-)