J. D. NEUHAUS Profi 025Ti, Руководство по эксплуатации

Страница: 94 / 218

powered by air !
Page 26
Direction of movement “lower”
with hose designation 3 or colour: red
AT T E N T I O N !
The control hoses must not be subject to
tensile load; adjust the strain-relief cables
accordingly.
Pull the bellows over the hose adapter and secure via
the central bolt, (see page 24, bottom).
C O N V E R S I O N F R O M E T O F I
Removal of E-controls as previously described (page 25).
Installation of FI-controls
Pull the bellows over the hose bundle for FI-control.
Remove approx. 80 mm of hose bundle protective
sheathing.
Screw the “straight screw connections” (Steck-fix)
for 4 mm hoses into the hose adapter (A/F 16).
With this type of control, strain-relief of the hand
controls takes place via the protective sleeve of the
hose bundle. For this purpose, the protective sleeve
is pushed onto the hose carrier and is secured using
a one-ear clamp.
Installation facilitation: Heat the protective sleeve
(hose sheathing) with a hot-air gun and grease the
hose carrier.
Slightly bend open the ring of the eye bolt in order to
attach the hose carrier.
Close the ring again to prevent detaching.
Insert the control hoses:
See illustration on page 24, top.
Compressed air
with hose designation 1 or colour: white
Direction of movement “lift”
with hose designation 2 or colour: green
Direction of movement “lower”
with hose designation 3 or colour: red
AT T E N T I O N !
The control hoses must not be subject to
tensile load; adjust the protective sleeve
accordingly.
Pull the bellows over the hose adapter and secure via
the central bolt (see illustration on page 24, bottom).
Conversion from rope control to air control:
Remove the rope control lever by removing the
M6 x 12 bolt from the control shaft.
The connecting surface of the hose adapter on the
valve housing is closed off by means of a disc with an
M8 x 16 countersunk screw. Following removal of the
countersunk screw and of the disc and dowel pin
(5 x 12 dowel pin), the hose adapter of air control can
be installed as described in the previous section.
I N I T I A L O P E R AT I O N