J. D. NEUHAUS Profi 025Ti, Руководство по эксплуатации

Страница: 176 / 218

powered by air !
OP E R AT I O N
Page 34
Within the EU, these controls are equipped with an
EMERGENCY STOP device (optional outside the EU).
In order to avert danger arising from the lifting move-
ment as quickly as possible, the pushbuttons must be
released; the movement of the load is interrupted
immediately.
Only in the case of failure of this stop function, must
the red EMERGENCY STOP button be firmly pressed. The
EMERGENCY STOP button engages. This results in the
closing of a separate check valve and the load hook
comes to rest instantaneously. The pushbuttons for
lifting and lowering now no longer function.
The EMERGENCY STOP button can be released again by
turning clockwise. It jumps back into place.
DA N G E R !
Never release the EMERGENCY STOP button
before the danger has been eliminated and
the stop function via the pushbuttons has
been restored.
R OP E C O N T R O L
With rope control, the lifting and lowering movements
are controlled directly. Both rope ends are connected to
one another via a handle, enabling precise one-hand
operation. The direction of movement is marked by
arrows on the handle.
The control elements for rope control and the energy-
switching component of the control valve on the motor
(reversing valve), are positively connected to one
another. This connection is designed in such a way, that
in an emergency, the control valve can be reset to a
stable neutral position. Thus, no additional EMERGENCY
STOP device is required.
왘
Lift: Carefully pull on the green rope with the green
handle pin. The load is lifted slowly.
왘
Pull harder on the rope, in order to increase the
lifting speed.
왘
Release the rope slightly in order to reduce the lifting
speed.
왘
Lower: Carefully pull on the red rope with the yellow
handle pin. The load is lowered slowly.
왘
Pull harder on the rope, in order to increase the
lowering speed.
왘
Release the rope slightly, in order to reduce the
lowering speed.
Your hoist is equipped with a direct-acting overload
protection in the form of a new type of safety clutch.
This safety clutch limits overload to 120 % of load-
carrying capacity, without the danger of failure due
to the load running back.
DA N G E R !
Only use attaching cables or attaching chains
which are suitable for the load. Attaching
must not be attempted by winding with the
lifting chain around the load.
AT TAC H I N G T H E L OA D
OVE R L OA D P R OT E C T I O N
Rope control
E M E R G E N C Y S TOP D E V I C E