Isuzu D-MAX 2020, Руководство владельца и водителя

Страница: 487 / 924

4-211
CONTROLS AND INSTRUMENTS
ADVICE
• Always keep the areas around the sensors clean. If there is dirt around the
sensors, the system may not operate properly.
• Do not subject the sensors or anything around the sensors to strong impact.
If an impact misaligns the position or direction of the sensors, the system may
not operate correctly. If a strong impact has occurred, be sure to contact the
nearest Isuzu Dealer.
• Do not install any accessories or apply any stickers to the sensors or within the
range of the sensors. Doing so may result in an erroneous operation. Before
installing accessories to areas around the sensors, contact the nearest Isuzu
Dealer.
• Do not do anything described below, because doing so may cause a
malfunction.
- Disassembly of the sensors
- Modification of the sensors or anything near the sensors
- Painting the sensors or anything near the sensors
• If the sensors or anything around the sensors need to be repaired, replaced,
removed, or installed, contact the nearest Isuzu Dealer.
• When washing the vehicle, do not spray water directly on the sensors or around
the sensors with a high-pressure washer. Due to the strong impact of high-
pressure water, the sensor may not work properly.
Detection Range
The sensors detect obstacles in the areas shown in the following figure.
RTUL40SF000201
a
b
c d
No. Description
a Approximately 60 cm (24 in) (front outer sensor)
b Approximately 60 cm (24 in) (rear outer sensor)
c Approximately 100 cm (39 in) (front inner sensor)
d Approximately 150 cm (59 in) (rear inner sensor)
5108428_sec04_CONTROLS AND INSTRUMENTS_P143-end.indd 211 2020/11/12 15:29:02