Isuzu D-MAX 2020, Руководство владельца и водителя

Страница: 245 / 924

3-95
PRE-DRIVING OPERATIONS AND ADJUSTMENTS
Installing a CRS
For crew cab models, we recommend installing the CRS on the second seat.
Before you install a CRS on the front passenger seat, raise the seatback so it is fully
upright and slide the passenger seat all the way backward. At this time, if there is a
gap between the seatback and the CRS, adjust the front passenger seat to reduce
the gap. Also, if you install a rearward-facing CRS on the front passenger seat, always
place the passenger side SRS airbag on-off switch in the "OFF" position (models with
passenger side SRS airbag on-off switch).
Passenger Side SRS Airbag On-Off
Switch → Refer to page 3-121
RTUL30SH011601
WARNING
• Carefully follow the instructions in the CRS manufacturer's instruction manual to
install the CRS.
• The seat belt cannot protect your child from death or serious injuries when it is
defective. Immediately contact your Isuzu Dealer and repair the seat belt that
does not function normally. Never use the CRS with the defective seat belt until
it is fixed.
• Make sure that installation is performed in compliance with all installation
instructions provided by the CRS manufacturer and make sure that the system
is secured properly. Improper installation may result in death or serious injuries
to the child in event of sudden stopping or accidents.
• When CRS is not in use, make sure that the CRS is properly secured to the seat
when it is not in use. Do not simply place a CRS on the seat without it being
secured to the seat.
• Never use a rearward-facing CRS on a seat protected by an active airbag in
front of it, death or serious injury to the child can occur.
NOTE
• The label on the passenger side sun
visor shows warning pictograms.
Details of the label are shown in the
figure.
5108428_sec03_PRE-DRIVING OPERATIONS.indd 95 2020/11/06 10:49:11