Isuzu D-MAX 2020, Руководство владельца и водителя

Страница: 435 / 924

4-159
CONTROLS AND INSTRUMENTS
Wheels may be locked and slip during sudden braking or braking on a slippery road
surface such as a snowy road. ABS is a device to prevent the wheels from by detecting
a slippery condition during braking and to secure directional stability and handling
stability of the vehicle. ABS is only to assist in slippery conditions and will not prevent
an accident if you exceed safe driving speeds for road conditions. Always drive safely.
Anti-lock Brake System (ABS)
CAUTION
• When the rear differential lock is operating (models with rear differential lock),
the ABS does not operate.
• The braking distance on slippery road surfaces is longer than that on a normal
dry paved road even with an ABS-equipped vehicle. In addition the braking
distance can be slightly longer in deep snow and on a gravel road when ABS is
operated. Therefore, always keep in mind the road condition and tire condition
(type of tires and worn condition), observe safe driving habits and drive the
vehicle while keeping a proper distance between vehicles.
• ABS does not prevent accidents if you do not drive safely. Drive the vehicle at a
safe speed.
• Install tires of the specified size, same brand and same tread design (including
winter tires) on all wheels. If different tires are installed, the braking distance
becomes longer and directional control stability of the vehicle decreases. This is
very dangerous.
• Steering during sudden braking (when the ABS is working) will feel slightly
different than it does when the brakes are not applied. Operate the steering
wheel carefully keeping this in mind.
ADVICE
• Driving in sand or on a muddy road may adversely affect the brakes and ABS
sensors. Wash the vehicle to remove sand and mud after operating the vehicle
in sandy or muddy conditions.
• Before washing the vehicle, provide necessary protection to prevent water from
being splashed on the ABS components (sensors and actuators). Especially
when using high-pressure washing, be careful not to allow water to be directly
sprayed onto the ABS components and their harness connectors.
5108428_sec04_CONTROLS AND INSTRUMENTS_P143-end.indd 159 2020/11/12 15:28:56