Isuzu D-MAX 2020, Руководство владельца и водителя

Страница: 760 / 924

6-84
SERVICE AND MAINTENANCE
1. Firmly apply the parking brake and put
the gearshift lever in the "R (reverse)"
position for manual transmission
models or put the selector lever
in the "P" position for automatic
transmission models. When changing
a front wheel, chock the rear wheel
diagonally opposite to the front wheel.
When changing a rear wheel, chock
the front wheel diagonally opposite to
the rear wheel.
2. Firmly apply the head of the jack to
the jacking point.
Handling the Jack
→ Refer to page 6-77
3. Raise the vehicle enough so that the
tire not quite clear of the ground.
5. Jack up the vehicle so that the tire is
clear of the ground completely.
6. Remove all the wheel nuts that have
been loosened, and then remove the
wheel.
ADVICE
• Remove the wheel being careful not
to damage the threads of the wheel
bolts.
• Do not put the wheel with its design
(outer) side down on the floor. It
may cause scratch on the wheel
surface.
CAUTION
• Do not loosen the wheel nuts too
much. The wheel bolts would be
damaged.
4. Using the wheel nut wrench, loosen
the wheel nuts just enough so that the
wheel remains stable in position. Do
not remove the wheel nuts yet.
5108428_sec06_SERVICE AND MAINTENANCE_P001-140.indd 84 2020/11/05 11:54:18