IBM PC Server 330, Руководство пользователя

Страница: 290 / 382

Ethernet Controller Messages
PCNTPK-DOS-5 There is already a packet driver at xxxx.
Explanation: The driver is already loaded at this memory location. It cannot be
loaded a second time at the same location.
Action: Do not load the driver again. If you want to load the driver at a different
memory location, specify another software interrupt address on the INT parameter.
PCNTPK-DOS-6
<
IRQ=int_no
>
should be between 0 and 15 inclusive.
Explanation: The specified IRQ is out of range for the Ethernet controller.
Action:
Use valid IRQ values.
PCNTPK-DOS-7 Packet driver failed to initialize the board.
Explanation: The board initialization failed.
Action: Perform the following steps:
1. Verify that the Ethernet enable jumper is set to the default (enable) position.
2. Go to “About the Test Programs” on page 233 to run the diagnostic utility.
PCNTPK-DOS-8
<
INT
=
packet_int_no
>
should be in the range 0x60 to 0x80.
Explanation: The specified software interrupt number is out of the allowable range.
Action: Specify a valid value for the INT parameter.
PCNTPK-DOS-12 PCI device IRQ number mismatch.
Explanation: The specified IRQ number does not match with the IRQ number
assigned by the PCI BIOS.
Action: Remove the IRQ setting.
PCNTPK-15 The device was not found.
Explanation: The driver cannot find an Ethernet controller.
Action: Perform the following steps:
1. Verify that the Ethernet enable jumper is set to the default (enable) position.
2. If the problem persists, go to “About the Test Programs” on page 233 to run the
diagnostic utility.
276
PC Server 330 User's Handbook