IBM PC Server 330, Руководство пользователя

Страница: 276 / 382

Ethernet Controller Messages
PCNTNW-NW-093 Cannot schedule interrupt time call back without an HSM
routine.
Explanation: The driver needs a Hardware Support Module routine before it can
schedule an interrupt time call back.
Action: Restart the server. If the error recurs, call for service.
PCNTNW-NW-094 Cannot set hardware interrupt without an HSM routine.
Explanation: The driver needs a hardware interrupt call back routine routine before
it sets the interrupt.
Action: Restart the server. If the error recurs, call for service.
PCNTNW-NW-095 Cannot add polling without an HSM routine.
Explanation: The driver needs an HSM polling routine before it can start the polling
process.
Action: Restart the server. If the error recurs, call for service.
PCNTNW-NW-126 The group bit in the node address override was cleared.
Explanation:
The IEEE address has a group bit indicating that an address belongs to
a group of stations. This bit is used only as a destination address; it cannot be used
as a source address. You tried to enter a source address with this bit set. The driver
cleared the group bit of the source address.
Action: None.
PCNTNW-NW-127 The local bit in the node address override was set.
Explanation: The local bit in the IEEE address format indicates that the addresses
are being managed locally. If you use the node address override capabilities of this
driver to enter a new address, the local bit should be set. You entered an address
without the local bit set. The driver has set the local bit.
Action: None.
PCNTNW-NW-164 The device was not found.
Explanation: The driver cannot find an Ethernet controller in the server.
Action: Perform the following steps:
1. Verify that the Ethernet enable jumper is set to the default (enable) position.
2. Go to “About the Test Programs” on page 233 to run the diagnostic utility.
262
PC Server 330 User's Handbook