IAI IA-101-TT-USB, Руководство по эксплуатации

Страница: 358 / 392

14. Supplemental Information
on Controller Menu Items
350
14.3. Drive-source Recovery Request and Operation-pause Reset Request
14.3.1 In the cases of Controllers Other Than SSEL, ASEL or PSEL Controllers
(1) Drive-source recovery request
[1] How to issue a drive-source recovery request A drive-source recovery request is required only in the
following case:

When you set I/O parameter No.44 to 1, drive power cut-off occurs. -  Recovery after the main
cause of cut-off is solved.
[2] How to issue a drive-source recovery request A drive-source recovery request can be issued using
one of the following methods:

Set I/O parameter No.44 to 1 (input selection function 014 = Drive-source cut-off reset input), and
then input the ON edge on input port No. 14

From the software menu, execute Controller (C)  Request Drive Power Recovery (P).
(2) Operation pause release request
[1] Case where an operation pause release request is required
An operation pause release request is required in any of the following cases:

When you set other parameter No.9 to 2, (Deadman SW recovery release according to type =
continuous operation release [during automatic operation only], stop according to Deadman SW
during automatic operation  recovery after release stop (operation pause release).

When you set other parameter No.10 to 2, (emergency stop recovery according to type =
continuous operation recovery during automatic operation only), emergency stop during automatic
operation  recovery after emergency stop release (operation pause release).

When you set other parameter No.11 to 2, (according to recovery type during safety gate open
recovery = continuous operation recovery (during automatic operation only), safety gate OPEN
during automatic operation  recovery after safety gate CLOSE (operation pause release).

When you set I/O parameter No.36 to 1, (input selection function 006 = pausing operation signal),
OFF level input on input port No.6 at automatic operation (pausing operation)

recovery after ON
level input on input port No.6 (operation pause release).
[2] How to issue an operation pause release request An operation pause release request can be issued
using one of the following methods:

Set I/O parameter No.35 to 1 (input selection function 005 = operation pause release signal), and
then input the ON edge on input port No.5.

From the software menu, execute Controller (C)  Request Release Pause (L).
Note) If the case in [2] of (1) and any of the cases in [2] of (2) are present at the same time, a
drive-source recovery request must be issued first, followed by an operation-pause reset request.