horsch 80910205, Руководство по эксплуатации

Страница: 80 / 218

7 Commissioning
This chapter contains information concerning the commissioning of the machine.
Before starting to operate the machine, the operator must have read and understood the operating
instructions.
Strictly comply with the chapter "Safety notes for the operator" when
o transporting the machine
o working with the machine
o hitching and unhitching trailers
• The machine must comply with the regulations of the national road traffic regulations.
• Vehicle owner (operator) as well as driver (operating person) are solely responsible for comply-
ing with the statutory regulations of the national road traffic regulations.
WARNING
Danger caused by crushing, shearing, cutting, winding up, being pulled in and
caught in the area of hydraulically or electrically actuated components.
Do not block any actuators on the Trac, which serve the purpose of directly executing hydraulic
or electric movements of components, such as e.g. folding, slewing and pushing processes. The
corresponding movements must automatically stop once you release the corresponding actuator.
This does not apply for equipment which
• are continuous or
• automatically controlled or
• require a floating or pressure position because of their function
7.1 Check suitability of Trac
WARNING
Danger of breakage during operation, insufficient stability and inadequate steering and
braking ability of the Trac if used for purposes other than the ones it is intended for!
• Perform a brake test in order to check whether the Trac reaches the required braking delay
also with a trailer.
Prerequisites for the suitability of the Trac are in particular:
• the permissible total weight
• the permissible axle loads
• the permissible tongue load at the coupling point of the Trac
• the bearing capacity of the assembled tyres
• the permissible trailer load must be sufficient
You find these data on the type plate or in the vehicle registration papers and in the operating
instructions of the Trac.
Calculating the actual values for total Trac weight, Trac axle loads and tyre bearing capaci -
ties as well as the required minimum ballasting
The permissible total weight of the Trac, as specified in the vehicle registration papers, must be
higher than the total of Trac curb weight and total weight.
80