Honda NC700 2012, Руководство по обслуживанию

Страница: 666 / 773

19-27
dummyhead dummyhead
HYDRAULIC BRAKE
DISASSEMBLY/ASSEMBLY
Disassemble the front brake caliper as following the
illustration.
• Be careful not to damage the piston sliding surface.
• If the caliper pin boot and bracket pin boot are hard
or deteriorated, replace it with a new one.
Place a shop towel over the pistons.
Position the caliper body with the pistons down and
apply small squirts of air pressure to the fluid inlet to
remove the pistons.
Clean the seal grooves with clean brake fluid.
Assembly is in the reverse order of disassembly.
• Apply locking agent to the caliper pin and bracket
pin threads.
• Replace the piston seals and dust seals with new
ones.
• Apply brake fluid to the caliper pistons and new
piston seals.
• Apply silicone grease to new dust seals.
• Install the pistons with the opening toward the pads.
• Apply Honda Bond A, Cemedine #540 or equivalent
to the brake pad retainer mating surface.
• Apply 0.4 g (0.01 oz) of silicone grease to the caliper
pin and bracket pin sliding surface.
BLEED VALVE
5.4 N·m (0.6 kgf·m, 4.0 lbf·ft)
DUST SEAL
CALIPER PISTON
CALIPER PIN BOOT
BRACKET PIN BOOT
CALIPER BODY
CALIPER BRACKET
PAD RETAINER
PISTON SEAL
PAD SPRING
BRACKET PIN
12 N·m (1.2 kgf·m, 9 lbf·ft)
CALIPER PIN
22 N·m (2.2 kgf·m, 16 lbf·ft)
BRAKE PAD PIN
17 N·m (1.7 kgf·m, 13 lbf·ft)
STOPPER RING
BRAKE PADS
Do not use high
pressure air or bring
the nozzle too close
to the inlet.