Honda NC700 2012, Руководство по обслуживанию

Страница: 24 / 773

1-19
dummyhead dummyhead
GENERAL INFORMATION
CRANKCASE/TRANSMISSION/BALANCER
CRANKSHAFT/PISTON/CYLINDER
ENGINE REMOVAL/INSTALLATION
ITEM Q'TY
THREAD TORQUE
REMARKS
DIA. (mm) N·m (kgf·m, lbf·ft)
Mainshaft bearing set plate bolt 3 6 12 (1.2, 9) Apply locking agent to the threads.
Coating width; 6.5 ± 1.0 mm (0.26 ±
0.04 in) except 2.0 ± 1.0 mm (0.08 ±
0.04 in) from tip
Shift drum bearing set plate bolt 2 6 12 (1.2, 9) Apply locking agent to the threads.
Coating width; 6.5 ± 1.0 mm (0.26 ±
0.04 in) except 2.0 ± 1.0 mm (0.08 ±
0.04 in) from tip
Balancer shaft bearing set plate
bolt 3 6 12 (1.2, 9) Apply locking agent to the threads.
Coating width; 6.5 ± 1.0 mm (0.26 ±
0.04 in) except 2.0 ± 1.0 mm (0.08 ±
0.04 in) from tip
Crankcase main journal bolt (new) 6 9 20 (2.0, 15) + 150° See page 14-30
Replace with a new one.
Crankcase 10 mm bolt 1 10 39 (4.0, 29)
Crankcase 8 mm bolt 3 8 24 (2.4, 18)
Crankcase 8 x 45 mm bolt 1 8 24 (2.4, 18) Apply locking agent to the threads.
Coating width; 6.5 ± 1.0 mm (0.26 ±
0.04 in) from tip
Crankcase 6 mm bolt 8 6 12 (1.2, 9)
ITEM Q'TY
THREAD TORQUE
REMARKS
DIA. (mm) N·m (kgf·m, lbf·ft)
Crankpin bearing cap bolt 4 6 10 (1.0, 7) + 90° See page 15-7
See page 15-12
Replace with a new one.
Apply engine oil to the threads and
seating surface.
Crankcase main journal bolt
(retightening) 6 9 20 (2.0, 15) + 120° See page 15-9
Apply engine oil to the threads and
seating surface.
ITEM Q'TY
THREAD TORQUE
REMARKS
DIA. (mm) N·m (kgf·m, lbf·ft)
Rear lower engine hunger nut 1 12 59 (6.0, 44)
Front lower engine hunger bolt 2 12 54 (5.5, 40)
Upper engine hunger bolt 2 12 54 (5.5, 40)
Rear upper engine hunger nut 1 12 54 (5.5, 40)
Step holder mounting socket bolt 4 8 32 (3.3, 24)
Drive sprocket bolt 1 10 54 (5.5, 40)
Starter motor terminal nut 1 6 10 (1.0, 7)
Water hose band screw 2 – – See page 16-18
See page 16-19
See page 16-24
See page 16-25