Honda NC700 2012, Руководство по обслуживанию

Страница: 595 / 773

17-24
dummyhead dummyhead
FRONT WHEEL/SUSPENSION/STEERING
WHEEL BEARING REPLACEMENT
Install the bearing remover head [1] into the bearing [2].
From the opposite side, install the bearing remover
shaft [3] and drive out the bearing from the wheel hub.
Remove the distance collar and drive out the other
bearing.
Never install the old
bearing, once the
bearing has been
removed, the
bearing must be
replaced with new
ones.
Drive in a new right side bearing [1] squarely with its
marked side facing up until it is fully seated.
Install the distance collar.
Drive in a new left side bearing squarely with its marked
side facing up until it is seated on the distance collar.
INSTALLATION
Install the side collars [1].
Install the front wheel between the fork legs.
Apply a thin coat of grease to the front axle sliding
surface.
Install the front axle [1] from left side.
Tighten the front axle to the specified torque.
TOOLS:
Bearing remover head, 20 mm
07746-0050600
Bearing remover shaft 07GGD-0010100
[1] [2] [3]
TOOLS:
Driver [2]
07749-0010000
Attachment, 42 x 47 mm [3] 07746-0010300
Pilot, 20 mm [4] 07746-0040500
[2]
[3]/[4] [1]
[1]
TORQUE: 74 N·m (7.5 kgf·m, 55 lbf·ft)
[1]