Honda NC700 2012, Руководство по обслуживанию

Страница: 664 / 773

19-25
dummyhead dummyhead
HYDRAULIC BRAKE
DISASSEMBLY/ASSEMBLY
Disassemble and assemble the rear master cylinder as
following the illustration.
• Be careful not to damage the boot.
• When removing and installing the snap ring, use the
special tool.
• Replace the piston, spring and cup as a set.
• Apply brake fluid to the master piston and cups.
• Apply brake fluid to the master cylinder inside.
• Do not allow the piston cup lips to turn inside out.
• Apply silicone grease to the push rod sliding area
and boot fitting area.
• Make sure the snap ring is firmly seated in the
groove.
• Replace the hose joint O-ring with a new one.
• Apply brake fluid to a new hose joint O-ring.
• Apply locking agent to the rear master cylinder hose
joint screw threads.
If the push rod joint is disassembled, adjust the push
rod length so that the distance from the center of the
master cylinder lower mounting hole to the center of the
joint pin hole is standard length as shown.
After adjustment tighten the push rod lock nut [1] to the
specified torque.
TOOL:
Snap ring pliers
07914-SA50001
O-RING
MASTER CYLINDER
HOSE JOINT
SPRING
SNAP RING
BOOT
17 N·m (1.7 kgf·m, 13 lbf·ft)
MASTER PISTON
PUSH ROD
PUSH ROD JOINT
PISTON CUP
RESERVOIR COVER
DIAPHRAGM
SET PLATE
RESERVOIR
1.5 N·m (0.2 kgf·m, 1.1 lbf·ft)
1.5 N·m (0.2 kgf·m, 1.1 lbf·ft)
STANDARD LENGTH: 85.0 – 87.0 mm (3.35 – 3.43 in)
TORQUE: 17 N·m (1.7 kgf·m, 13 lbf·ft)
85.0 – 87.0 mm
(3.35 – 3.43 in)
[1]