Honda NC700 2012, Руководство по обслуживанию

Страница: 461 / 773

12-106
dummyhead dummyhead
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
DISASSEMBLY
Remove clutch guide 1 [1], clutch guide 2 [2] and
washers [3] from the clutches.
Remove the clutch assemblies [1] and O-rings [2] from
the primary driven gear.
• Do not disassemble the clutch assembly.
• The No.1 clutch assembly (for inner mainshaft) and
No.2 clutch assembly (for outer mainshaft) are the
same parts.
CLUTCH CLEARANCE INSPECTION
Set a dial indicator on the end plate [1] with the plate
bottomed.
Measure the clearance by lifting the end plate against
the snap ring and record it.
Perform this inspection at three points in 120° apart.
If the measured value exceeds the service limit, replace
the clutch assembly.
ASSEMBLY
Coat new O-rings [1] with engine oil and install them
into the grooves in the primary driven gear.
Install the clutch assemblies [2] onto the primary driven
gear.
[2]
[1]
[3]
[1]
[2]
SERVICE LIMIT: 2.0 mm (0.08 in)
[1]
120°
120°
120°
[1]
[2]