Honda NC700 2012, Руководство по обслуживанию

Страница: 253 / 773

6-10
dummyhead dummyhead
ELECTRIC STARTER
STARTER RELAY SWITCH
INSPECTION
Remove the maintenance lid (page 21-6).
Shift the transmission into neutral.
Turn the ignition switch ON and engine stop switch " ".
Push the starter switch.
The coil is normal if the starter relay switch [1] clicks.
If you don't hear the starter relay switch "CLICK",
release the starter relay switch/shock rubber from the
battery box tabs [2] and inspect the starter relay switch
using a procedure below.
STARTER RELAY INPUT VOLTAGE
Turn the ignition switch ON and engine stop switch " ".
Measure the voltage between the Yellow/red (+) wire
terminal at the starter relay switch 4P (Red) connector
[1] and ground (–).
If the battery voltage appears only when the starter
switch is pushed with the ignition switch turned ON and
engine stop switch " ", the starter relay input voltage is
normal.
GROUND LINE (NC700X/XA/S/SA)
Disconnect the starter relay switch 4P (Red) connector
[1].
Check for continuity between the Green/red wire of the
wire harness side (ground line) and ground.
If there is continuity when the transmission is in neutral
or when the clutch is disengaged and the sidestand is
retracted, the ground circuit of the relay coil is normal.
(In neutral, there is a slight resistance due to the diode.)
[1]
[2]
[1]
[1]