Honda NC700 2012, Руководство по обслуживанию

Страница: 389 / 773

12-34
dummyhead dummyhead
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
3. Shift Switch Input Line Open Circuit Inspection
Disconnect the PCM 33P (Black) connector.
Check for continuity between the wire harness side
left handlebar switch connector [1] and PCM 33P
(Black) connector [2] terminals.
Is there continuity?
YES – GO TO STEP 4.
NO – • Open circuit in the Blue/yellow wire
• Open circuit in the Light green/red wire
4. Shift Switch Input Line Short Circuit Inspection
Check for continuity between the wire harness side
PCM 33P (Black) connector [1] terminals and
ground.
Is there continuity?
YES – • Short circuit in the Blue/yellow wire
• Short circuit in the Light green/red wire
NO – Replace the PCM with a known good one,
and recheck.
DTC 44-1 (EOT SENSOR LOW
VOLTAGE)
• If the PCM is replaced, perform the following:
– Key Registration Procedure (page 23-6)
– Clutch Initialize Learning Procedure (page 12-120)
1. EOT Sensor System Inspection
Check the EOT sensor with the HDS pocket tester.
Is about 0 V indicated?
YES – GO TO STEP 2.
NO – Intermittent failure
Connection: Blue/yellow – A7
Light green/red – A30
TOOL:
Test probe
07ZAJ-RDJA110
A30
A7
[2]
Lg/R
Bu/Y
[1]
NC700XD:
NC700SD:
A30
A7
[2]
Lg/R
Bu/Y
[1]
Connection: A7 – Ground
A30 – Ground
TOOL:
Test probe
07ZAJ-RDJA110
[1]
A7
A30