Honda NC700 2012, Руководство по обслуживанию

Страница: 558 / 773

16-15
dummyhead dummyhead
ENGINE REMOVAL/INSTALLATION
Remove the rear engine hunger nuts [1], collars [2] and
bolts [3].
Carefully maneuver the engine and remove it out of the
frame to the right.
During engine removal, hold the engine securely and
be careful not to damage the frame and engine.
ENGINE INSTALLATION (NC700X/XA/S/
SA)
• All the engine mounting bolts and nuts loosely
install, then tighten the bolts and nuts to the
specified torque in the specified sequence.
• Note the direction of the engine hanger bolts.
– Front lower right side [1]: 12 x 55 mm bolt and 20
mm collar
– Front lower left side [2]: 12 x 80 mm bolt and 41
mm collar
– Upper right side [3]: 12 x 45 mm bolt and 10 mm
collar
– Upper left side [4]: 12 x 35 mm bolt
– Rear upper side: 12 x 276 mm bolt, 37 mm collar
(right side) [5] and 47 mm collar (left side) [6]
– Rear lower side: 12 x 168 mm bolt and 10 mm
collar (right side) [7]
• Place the jack or other adjustable support under the
engine.
• The jack height must be continually adjusted to
relieve stress for ease bolt installation.
• Carefully align the mounting points with the jack to
prevent damage to engine, frame, water hose, wires
and cables.
• Route the hoses, wires and cables properly (page 1-
25).
During engine
installation, hold the
engine securely
and be careful not
to damage the
frame and engine.
Place the engine in the frame, then loosely install all the
bolts, nuts and collars.
Tighten the rear lower engine hunger nut [1] to the
specified torque.
Left side: Right side:
[2]
[2]
[1]
[3]
[7] [2]
[5] [6] [3] [4]
[1]
TORQUE: 59 N·m (6.0 kgf·m, 44 lbf·ft)
[1]