Honda NC700 2012, Руководство по обслуживанию

Страница: 604 / 773

17-33
dummyhead dummyhead
FRONT WHEEL/SUSPENSION/STEERING
INSTALLATION
Route the wires and
cables properly
(page 1-25).
Install the fork leg through the bottom bridge and top
bridge while aligning top surface of fork pipe with the
top surface of top bridge.
Tighten the bottom bridge pinch bolts [1] to the
specified torque.
If the fork cap [2] is loosened, tighten the fork cap to the
specified torque.
Tighten the top bridge pinch bolts [3] to the specified
torque.
NC700XA/XD/SA/
SD:
Install the front brake caliper/bracket assembly [1] and
tighten new brake caliper mounting bolts [2] to the
specified torque.
Install the following:
– Front fender (page 2-28)
– Front wheel (page 17-24)
STEERING STEM
REMOVAL
NC700X/XA/XD:
Remove the following:
– Shroud/side cover (page 2-14)
– Handlebar
– NC700X/XA (page 17-10)
– NC700XD (page 17-12)
Disconnect the ignition switch 2P (Brown) connector [1]
and immobilizer receiver 4P (Black) connector [2].
Release the each wire harness from the clamps [3].
TORQUE: 39 N·m (4.0 kgf·m, 29 lbf·ft)
TORQUE: 22 N·m (2.2 kgf·m, 16 lbf·ft)
TORQUE: 22 N·m (2.2 kgf·m, 16 lbf·ft)
Align
[3]
[1] [2]
TORQUE: 30 N·m (3.1 kgf·m, 22 lbf·ft)
NC700XA/XD/SA/SD: [2]
[1]
[1] [2]
[3]
[3] NC700X/XA:
[1] [2]
[3] [3] NC700XD: