Holip HLP-A100 Series, Руководство по эксплуатации

Страница: 95 / 187

HLP-A100 Series Operating Manual
HLP-A100 Series
-
88
-
C05.30 Function Description Range Unit Default Setting
Terminal DO1 Digital
Ouput
0~108 0
C05.3* Digital Output
Attention: Because the DO1 also can be used as pulse output, so select [0]
digital output in C05.60 to make this parameter active;
C05.31 Function Description Range Unit Default Setting
Terminal DO2 Digital
output
0~108 0
C05.40 Function Description Range Unit Default Setting
Relay Function 0~108 5, 9
C05.4* Relay
[22] Speed down, same as speed up [21] ;
[23] Set-up select, see C00.10 (Active Set-up) ;
[26] Precise stop inverse ,the f unction is available for C05.15/DI4 only;
[27] Start-Precise stop, same as [26], but including start;
[28] Catch up, select catch up to increase the resulting reference value
by the percentage set in par. C03.12;
[29] Slow down, select slow down to reduce the resulting reference
value by the percentage set in par. C03.12;
[32] Pulse input, Select Pulse input when using a pulse sequence as
either reference or feedback. Scaling is done in par. group C05.5*, the
f unction is available for C05.15/DI4 only;
[34] Ramp bit0
、
bit0
、
bit1 used for select acceleration or deceleration;
[35] Ramp bit1 , same as [34] ;
[60] Counter A (up) ;
[62] Reset counter A, to clear counter A to “0”;
[63] Counter B (up) ;
[65] Reset counter B, to clear Counter B to “0”;
[70] Wobble start command, see parameter group C30*;
[71] Wobble reset, see parameter group C30*;
[72] Wobble initialization, see parameter group C30*;
[90] Low water level, see parameter group C25*;
[91] High water level, see parameter group C25*;
[92] Scarcity water level, see parameter group C25*;
[93] Over run water level, see parameter group C25*;