Figure 86: MSL8048 and MSL8096 half-height drive bay locations
2.
Remove the face plate covering the drive bay by removing the screws holding it in place.
Remove one drive bay cover to install a half-height tape drive; remove two drive bay covers to install a full-
height tape drive.
3.
Holding the tape drive by the handle and supporting it from the bottom, slide it into the drive bay until it is
flush with the back of the library.
4.
To secure the tape drive to the chassis, use a torque driver to tighten the thumbscrews on the drive sled to
6 inch pounds or 0.68 N m.
If a torque driver is not available, use a #2 Phillips screwdriver to tighten the thumbscrews until a low initial
threshold torque achieves a snug tight condition.
Upgrading and servicing the library
215
