device knows the usage count for all of the cleaning cartridges, the library will choose the one with the highest
usage count.
Auto cleaning is disabled by default. You can enable automatic cleaning even if there are no cleaning
cartridges in the library. In this case, the library will display a warning message.
CAUTION:
Only enable automatic cleaning in either the backup application or the library, not both.
Procedure
1.
From the Home screen, press
Previous
or
Next
until the screen displays
Configuration
. Press
Enter
to
select.
2.
Press
Previous
or
Next
until the screen displays
Configure Auto Cleaning
. Press
Enter
to select.
3.
The screen displays
Auto Cleaning Disabled
or
Auto Cleaning Enabled
depending on the current
setting. To change the auto cleaning configuration, press
Enter
.
4.
Press
Previous
or
Next
until the screen displays the configuration you want. Press
Enter
.
Restoring factory defaults (Configuration > Restore Defaults)
The library can reset most of the configurations to the factory defaults, while retaining the settings necessary
to use the RMI. The library will perform an inventory after the defaults are restored.
The restored settings are:
• SCSI addresses: The SCSI ID for the bottom drive is 4; the SCSI ID for the top drive is 5. The library will
no longer recall a drive that has been removed.
• Fibre Channel drive configuration: Automatic speed, auto port type
• Master drive: reset to Drive 1 or the lowest numbered existing drive
• Active slots: maximum possible
• Library mode: Automatic
• Loop: No
• Event log levels and filter: continuous trace and all levels and filters active (for Service use only)
• Barcode reader label length: 8
• Barcode reader alignment: Left
• Error recovery: On
• Mailslot configuration: mailslot disabled
• Auto clean: disabled
• SNMP: disabled, but saved addresses do not change
• E-mail notification: disabled, but configurations retained
The following settings are not reset:
Restoring factory defaults (Configuration > Restore Defaults)
111
