HEIDENHAIN TNC 620 Programming Station, Руководство пользователя

Страница: 556 / 695

Test Run and Program Run
16.1 Graphics (option 20)
16
556
HEIDENHAIN | TNC 620 | ISO Programming User's Manual | 9/2016
16.1 Graphics (option 20)
Application
In operating modes
Program run, single block
and
Program
run, full sequence
and the operating mode
Test run
the TNC
graphically simulates a machining operation.
The TNC features the following views:
Plan view
Projection in three planes
3-D view
In the
Test run
operating mode, you can also use the
3-D line graphics.
The TNC graphic depicts the workpiece as if it were being
machined with a cylindrical end mill.
If a tool table is active, the TNC also considers the entries in the
LCUTS, T-ANGLE and R2 columns.
The TNC will not show a graphic if
the current program has no valid workpiece blank definition
no program is selected
with blank form definition with a subprogram, the BLK FORM
block was not yet run
The simulation of programs with 5-axis machining or
tilted machining might run at reduced speed. With
the MOD menu
Graphic settings
you and decrease
the
Model quality
and in that way increase the
speed of simulation.
Graphics without Option #20 Advanced graphic features
Without option 20 no model is available in the
Program run, single
block
and
Program run, full sequence
operating modes and the
Test run
operating mode.
The
P GRAPHICS
and
GRAPHICS
soft keys are dimmed.
The line graphic in
Programming
operating mode also functions
without option 20.