HEIDENHAIN TNC 620 Programming Station, Руководство пользователя

Страница: 520 / 695

Manual Operation and Setup
14.7 Using a 3-D touch probe (option 17)
14
520
HEIDENHAIN | TNC 620 | ISO Programming User's Manual | 9/2016
Writing measured values from the touch probe
cycles to the preset table
Use this function if you want to save measured
values in the machine coordinate system (REF
coordinates). If you want to save measured values in
the workpiece coordinate system, press the
ENTER
IN DATUM TABLE
soft key.
Further Information: "Writing measured values from
the touch probe cycles to a datum table", page 519
With the
ENTRY IN PRESET TABLE
soft key, the TNC can write
the values measured during any probe cycle in the preset table.
The measured values are then stored referenced to the machine
coordinate system (REF coordinates). The preset table has the
name PRESET.PR, and is saved in the directory TNC:\table\.
Select any probe function
Enter the desired coordinates for the datum in the designated
input boxes (depends on the touch probe cycle being run)
Enter the preset number in the
Number in table:
input box
Press the
ENTRY IN PRESET TABLE
soft key. The TNC saves the
datum in the preset table under the entered number
Preset number is not available: The TNC saves the row only
after pressing the
OK
soft key (Create row in table?)
Preset number is protected: Press the
OK
soft key and the
active preset will be overwritten
Preset number is password-protected: Press the
OK
soft key,
enter the password and the active preset will be overwritten
If writing to the table row is not possible due to a
lock, the control displays a message. The probing is
not aborted, however.