HEIDENHAIN TNC 620 Programming Station, Руководство пользователя

Страница: 571 / 695

Test run 16.4
16
HEIDENHAIN | TNC 620 | ISO Programming User's Manual | 9/2016
571
Test run
up to a certain block
With the
STOP AT
function the TNC executes a
Test run
up to the
block with block number
N
.
To stop the
Test run
at any block, proceed as follows:
Press the
STOP AT
soft key
Stop at: N =
Enter the block number at which the
simulation should stop
Program =
Enter the name of the program
containing the block with the selected block
number. The control displays the name of the
selected program; if the stop should be executed
in a program that was called with
%
, enter this
name.
Repetitions =
If
N
is located in a program section
repeat, enter the number of repeats that you want
to run.
Default 1: The control stops before
N
is simulated
Possibilities in stopped condition
If you interrupt the
Test run
with the
STOP AT
function, you have
the following possibilities in this stopped condition:
Block skip
enable or disable
Optional program stop
enable or disable
Modify graphics resolution and model
Modify the NC program in the
Programming
operating mode
If you modify the NC program in the
Programming
operating mode
the simulation behaves as follows:
Modification before the interruption point: The simulation
restarts at the beginning
Modification after the interruption point: Positioning at the
interruption point is possible with
GOTO