HEIDENHAIN TNC 620 Programming Station, Руководство пользователя

Страница: 546 / 695

Manual Operation and Setup
14.11 Tilting the working plane (option 8)
14
546
HEIDENHAIN | TNC 620 | ISO Programming User's Manual | 9/2016
The control uses the following transformation types
for tilting:
COORD ROT
if a
PLANE
function was previously executed
with
COORD ROT
after
PLANE RESET
with corresponding configuration
of the machine parameter
CfgRotWorkPlane
(no. 201200) by the machine
tool builder
after starting the control
after switching the kinematics
after running the cycle
G80
TABLE ROT
if a
PLANE
function was previously executed
with
TABLE ROT
with corresponding configuration
of the machine parameter
CfgRotWorkPlane
(no. 201200) by the machine
tool builder
after starting the control
after switching the kinematics
after running the cycle
G80
To deactivate manual tilting
To deactivate, set the appropriate operating modes to
Inactive
in
the
Tilt working plane
menu.
Even if the
3D-ROT
dialog in the
Manual operation
mode is set
to
Active
, resetting the tilting (
PLANE RESET
) with an active basic
transformation still functions correctly.