HEIDENHAIN TNC 620 Programming Station, Руководство пользователя, Страница: 204 / 695

Tools
5.2 Tool data
5
204
HEIDENHAIN | TNC 620 | ISO Programming User's Manual | 9/2016
Editing the tool table
The tool table that is active during execution of the part program is
designated TOOL.T and must be saved in the
TNC:\table
directory.
Other tool tables that are to be archived or used for test runs are
given different file names with the extension .T. By default, for the
Test run
and
Programming
modes the TNC also uses the TOOL.T
tool table. In the
Test run
mode, press the
TOOL TABLE
soft key to
edit it.
To open the tool table TOOL.T:
Select any machine operating mode
Select the tool table: Press the
TOOL TABLE
soft
key
Set the
EDIT
soft key to
ON
If you edit the tool table, the selected tool is locked.
If this tool is required in the NC program being used,
the TNC shows the message:
Tool table locked
.
If a new tool is created the length and radius
columns remain empty until you enter values. If it is
attempted to insert such a newly created tool, the
control aborts with an error message. This means
you cannot insert a tool for which no data has been
entered.
Displaying only specific tool types (filter setting)
Press the
TABLE FILTER
soft key
Select the tool type by pressing a soft key: The TNC only shows
tools of the type selected
Cancel the filter: Press the
SHOW ALL
soft key
The machine tool builder adapts the features of the
filter function to the requirements of your machine.
Refer to your machine manual.