HBM GEN3i, Руководство пользователя

Страница: 1091 / 1160

Triggering
Channel trigger/qualifier 1 per channel; fully independent per channel, software selectable either trigger or qualifier
Pre
-
and post
-
trigger length 0 to full memory
Maximum trigger rate 400 triggers per second
Manual trigger (Software) Supported
External Trigger In
Selection per card User selectable On/Off
Active edge Rising/Falling mainframe selectable, identical for all cards
Minimum pulse width 500 ns
Delay
±
1 µs + maximum 1 sample period (for decimal and binary time base)
Send to External Trigger Out User can select to forward External Trigger In to the External Trigger Out BNC
External Trigger Out
Selection per card User selectable On/Off
Active level High/Low/Hold High; selectable per mainframe, identical for all cards
Pulse width High/Low: 12.8 µs
Hold high: Active from first mainframe trigger to end of recording
Pulse width created by mainframe
Delay
516 µs
±
1 µs + maximum 1 sample period using decimal time base
504 µs
±
1 µs + maximum 1 sample period using binary time base
Cross channel triggering
Measurement channels Logical OR of triggers from all measured signals
Logical AND of qualifiers from all measured signals
Calculated channels
Logical OR of triggers from all calculated signals (RTC and RT
-
FDB)
Logical AND of qualifiers from all calculated signals (RTC and RT
-
FDB)
Analog channel trigger levels
Levels Maximum 2 level detectors
Resolution 16 bit (0.0015%); for each level
Direction Rising/Falling; Single direction control for both levels based on selected mode
Hysteresis 0.1 to 100% of Full Scale; defines the trigger sensitivity
Pulse detect/reject Disable/Detect/Reject software selectable. Maximum pulse width 65 535 samples
dY/dT conversion dY: 16 bit (0.0015%) for both levels
dT: 1 to 1023 samples. dT setting shared for both levels
Analog channel trigger modes
Basic POS or NEG crossing; single level
Dual level One POS and one NEG crossing; Two individual levels, OR
-
ed
Window
Arm/trigger and a disarm level; Trigger on peak level changes in a uni
-
polar signal
Dual Window
Arm/trigger/disarm per level; Trigger on peak level changes in a bi
-
polar signal
Sequential One arm and one trigger level; eliminate false triggering due to noise or hysteresis
Analog channel qualifier modes
Basic Above or below level check. Enable/disable trigger with single level
Dual (level) Outside or within bounds check. Enable/disable trigger with dual level
Trigger hold off Disable channel trigger for 1 to 65 535 samples after trigger detected
Maximum hold off time depends on sample rate
Interval timer
Modes Less than, trigger when rate is too low
More than, trigger when rate is too high
Between, trigger when rate between lower and upper limit
Not between, trigger when rate is not between lower and upper limit
Interval timers Start timer and width Timer
Timer value 1 to 65 535 samples
Event counter Counts channel trigger events before card trigger is activated
1 to 256 trigger events
GEN3i
I3763-3.1 en HBM: public 1091