If VSP is selected:
Which Hayward Unique Address?
If using a VSP for your accessory
pump, you’ll be asked what is the Hayward Unique Address (HUA). If
a value is already shown in the box, advance to the next screen. If
no value is shown, selecting the box will bring you to a table show-
ing all detected devices. Select the proper HUA from the table and
touch the Done button. The address should now be shown in the
box and you can advance to the next screen to continue the VSP
configuration.
Pump Capacity -
Set the minimum and maximum RPM of the pump.
Refer to your pump manual for more information.
Permitted User Setting -
The VS Omni will automatically calculate
these values based on the minimum and maximum RPM that were
previously entered. They can be changed as desired.
Speed Presets -
Set the Low Pump Speed %, Medium Pump Speed
%, and High Pump Speed %, presets. These presets will be used
when setting schedules for your pump.
Does Accessory have a Valve?
Select whether the accessory requires a valve to change
position when in use.
If Yes is selected:
How Many?
Select how many valves are used for the accessory.
Where is the Valve(s) Wired?
Selecting the box will bring you to a table show-
ing all detected low voltage relays. Select the relay(s) that is wired to the ac-
cessory valve(s), then advance. The valve(s) should now be shown in the box.
Advance to the next screen to continue accessory configuration.
Would You Like to Enable Priming?
Select whether you want the pump to prime when
turned on. This will turn the pump on at high speed for 3 minutes to establish normal
water flow every time the pump is activated after being off for at least 30 seconds.
If Yes is selected:
Enter Priming Duration:
Input the number of minutes that you want the pump
to prime for. This setting is configurable from 0-15 minutes. Once priming has
finished, the pump will run in the speed that it was chosen to run at.
Freeze Protection Enabled?
Freeze protection is used to protect the pool and plumbed
equipment against freeze damage during cold temperatures. If freeze protection is en-
abled AND the air temperature falls below the freeze threshold (refer to pump configura-
tion), the VS Omni will turn on the accessory pump to circulate the water.
If Yes is selected:
Freeze Protect Speed?
This is the speed of the pump while freeze protection
is active. Select the desired pump speed %. NOTE: this option only appears if
the pump is a two speed pump or a variable speed pump.
37
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
