Smart Relays
Like VSPs, Smart Relays rely on communication from the Hub. Their 4 conductor cable is wired to
the same connector as a VSP. Wire the cable as shown below. Up to two Smart Relays can be con-
trolled by the VS Omni. In addition to communication wiring, the Smart Relay will be wired to high
voltage pool equipment shown on page 13.
Valve Actuators
When wired for 230 VAC, the VS Omni can control up to two valve actuators which allow automated
control of pool/spa, water features, cleaners or solar heating. The VS Omni is compatible with stan-
dard valve actuators manufactured by Hayward, Pentair/Compool, and Jandy. Actuators have 15 ft
cables that are terminated with connectors that plug directly into the Hub as shown on page 10.
Temperature Sensors
The Hub utilizes 10K ohm thermistor type sensors with 15 ft cable. If a longer cable is required, con-
tact the Hayward service dept. (908-355-7995) for information on suitable cable types and splices.
Temperature sensors are wired to the 8 position connector shown on page 10 and on the follow-
ing page. To unlock, push on the corresponding lever with a small tool as shown. When pushed,
the connector will be open and able to receive the wire lead. For best results, strip back leads 1/8"
before inserting. After the wire is fully inserted, release the lever and the wire will lock in place.
Green
White
Black
Red
Smart Relay Connection
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
14
