About the Configuration Wizard
The VS Omni Configuration Wizard will ask you general questions relating to your pool or spa and
specific questions about connected pool equipment. Because this process may take some time, do
not begin to configure the VS Omni unless you can dedicate at least 15 minutes or more. Configuring
the VS Omni requires knowledge of all of the connected pool equipment.
If you are asked a question and don’t know the answer, in many cases you’ll be able to skip the
question and proceed. In some cases the Configuration Wizard will require an answer. Answer the
question to the best of your ability and take note as you’ll be able to go back into the Configuration
Wizard at a later time to make changes.
There are four different options for configuring the VS Omni: Pre-Programmed configuration, Typical
configuration, Advanced configuration, and Load Existing configuration. The differences between
these Configuration Wizards are described below.
Pre Programmed Configuration
This Configuration Wizard is the most basic and takes the least amount of time to complete. This op-
tion should be used if your system has only one variable speed pump, one heater (gas/heat pump),
and one Smart Relay for a light, an air sensor, and a water sensor.
The Pre-Programmed Configuration option also comes with the following pre-programmed sched-
ules:
1. Filter Pump - 8:00 AM to 8:00 PM / All Week / Medium Speed
2. Light - 7:00 PM to 11:00 PM / All Week
See page 25 for a full Pre-Programmed Configuration guide.
Typical Configuration
Use this Configuration Wizard if you have at least one variable speed pump and up to 2 Smart Relays
in your system. See page 25 for a full Typical Configuration guide.
Advanced Configuration
This Configuration Wizard is the most detailed and takes the most amount of time to complete. This
option can be used regardless of the number of variable speed pumps and Smart Relays in your
system. Use this option if you are managing two bodies of water, using valves, multiple heaters (gas/
heat pump + solar), and/or interlocks. See page 27 for a full Advanced Configuration guide.
Load Existing Configuration
This option should be used if you already have a pre-made configuration loaded onto a thumb drive
that is ready to be uploaded to the VS Omni.
Navigation
The Configuration Wizard has been designed to be intuitive allowing most users the ability to navi-
gate with little instruction. Here are a list of commonly used buttons are explained:
23
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
