Hayward 2007-Current Heaters
Refer to the instructions in the heater manual for “2-wire Remote Thermostat” operation under
“Remote Control Connections” and the diagram below:
1. Turn off power to heater.
2. Wire Hub to the heater terminals that have the Orange & White connections (see diagram).
3. Turn heater power back on.
4. Use the “MODE” key on the heater keypad to put the control into “STANDBY” mode.
5. Press and hold both the “DOWN” and “MODE” keys for 3 seconds until the display shows the
code “bo”.
6. Be sure to put the heater’s control in either “POOL” or “SPA” mode.
7. The Hub will now control the heater.
To configure the heater for 2- wire remote
thermostat control, use the “MODE” key on the
heater keypad to put the control into “STANDBY” mode.
Then press and hold both the “DOWN” and “MODE”
keys for 3 seconds until the display shows the code “bo”.
Orange
Wire
White
Wire
Do not remove jumper
Terminal block located at
electrical junction box
Dipswitch located on heater
circuit board
PK
W
R
BK
R
ON
BYP
ASS
ºC
OFF
ºF
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
18
