feature pump, you’ll be asked what is the Hayward Unique Address
(HUA). If a value is already shown in the box, advance to the next
screen. If no value is shown, selecting the box will bring you to a
table showing all detected devices. Select the proper HUA from the
table and touch the Done button. If unsure of the HUA, refer to the
pump’s manual for instructions on how to determine the pump’s HUA.
Once selected, the address should now be shown in the box and you
can advance to the next screen to continue the VSP configuration.
Pump Capacity -
Set the minimum and maximum RPM of the pump.
Refer to your pump manual for more information.
Permitted User Setting -
The VS Omni will automatically calculate
these values based on the minimum and maximum RPM that were
previously entered. They can be changed as desired.
Speed Presets -
Set the Low Pump Speed %, Medium Pump Speed
%, and High Pump Speed %, presets. These presets will be used
when setting schedules for your pump.
Does Water Feature have a Valve?
Select whether the water feature requires a valve to
change position when in use.
If Yes is selected:
How Many?
Select how many valves are used for the water feature.
Where is the Valve(s) Wired?
Selecting the box will bring you to a table show-
ing all detected low voltage relays. Select the relay(s) that is wired to the water
feature valve(s), then advance. The valve(s) should now be shown in the box.
Advance to the next screen to continue.
Would You Like to Enable Priming?
Select whether you want the pump to prime when
turned on. This will turn the pump on at high speed for 3 minutes to establish normal
water flow every time the pump is activated after being off for at least 30 seconds.
If Yes is selected:
Enter Priming Duration:
Input the number of minutes that you want the pump
to prime for. This setting is configurable from 0-15 minutes. Once priming has
finished, the pump will run in the speed that it was chosen to run at.
Freeze Protection Enabled?
Freeze protection is used to protect the pool and plumbed
equipment against freeze damage during cold temperatures. If freeze protection is en-
abled AND the air temperature falls below the freeze threshold (refer to pump configura-
tion), the VS Omni will turn on the water feature pump to circulate the water.
If YES is selected:
Freeze Protect Speed?
This is the speed of the pump while freeze protection
is active. Select the desired pump speed %. NOTE: this option only appears if
the pump is a two speed pump or a variable speed pump.
35
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
