Global Contract Licence 2, Руководство по установке

Страница: 89 / 100

•Page globalcontract.com 88
GLOBAL
Contract
• Fall 2017
Wheel Controls
How to set memory:
Run/Drive the table to the position you will store,
sitting or standing.
(This device have 5 memories position memories)
Press menu “stand” icon 1 time to come
to set memory menu.
Calibrate:
Measure the distance between the fl oor and the top
of the table sheet.
Press menu “stand” icon 2 times to come
to calibrate menu.
Use arrow up and down to navigate to set memory
setting.
Press Menu/Enter, and the value are stored.
The display confi rm by fl ashing 3 times and then
returns to normal mode.
Press Menu/Enter to confi rm
Press Menu/Enter to confi rm
Press Menu/Enter, and the value are stored.
Press Menu/Enter, and the value are
stored.
Adjust the fi gures to the selected value with the
arrows up or down.
1
5
CAL
28
.
0
Upper limit:
Set the upper limit if there are limited
space in height.
Press menu “stand” icon 3
times to come to set memory menu.
Units:
Choose between metric or imperial
system.
Press menu “stand” icon 5
times to come to set memory menu.
Error codes:
Reset Away:
Press menu “stand” icon 6
times to come to set memory menu.
Lower limit:
Set the lower limit if there are device/
equipment which could create a risk
of pinching or risk for table damages.
Press menu “stand” icon 4
times to come to set memory menu.
Adjust the fi gures to the chosen level
with the arrows up or down.
Press Menu/Enter to confi rm. Press Menu/Enter to confi rm.
1. Hard stop
2. Back off
3. Soft top
4. Waiting for button
5. Waiting for button release.
6. Motor lost
Overheating. Thermometer fl ashing,
wait 10 minutes for motor cooling.
Adjust the fi gures to the chosen level
with the arrows up or down. Adjust the fi gures to the chosen level
with the arrows up or down.
Press Menu/Enter, and the value are
stored.
Press Menu/Enter, and the value are
stored.
Press Menu/Enter, and the value are
stored.
Press ‘down” and hold until the columns
have gone to the lowest position.
Do reset if any parts have been changed
of if you discover interference between
the columns.
Please note that the fi gures count
from the table top surface.
Please note that the fi gures count from
the table top surface/ calibrated level.
UL
50
.
0
LL
27
.
5
UN
RES
3
INSTALLATION GUIDELINES