Global Contract Licence 2, Руководство по установке

Страница: 29 / 100

•Page globalcontract.com 28
GLOBAL
Contract
• Fall 2017
INSTALLATION GUIDELINES
L2CRSxxxx
STEP 1: Unpack and inspect individual pieces for damages or missing hardware
STEP 2: Pick a clean unobstructed area to assemble desk. It is advisable to assem-
bly of this product upside down.
STEP 3: Determine position of left and right gables with exposed Blum connectors
facing inside of assembly.
a. install levellers into the T nut inserts, use mallet to install in pre-drilled
holes on the bottom of the gables.
b. On the top edge, install Blum Connector screws into the pre-drilled
holes. Since the Gables can be used either left or right, 2 holes are pre-
drilled, select the hole that is closest to underside of completed assembly
to insure proper alignment.
STEP 4: Full Modesty Panel, Install Blum Connector screws in pre-drilled holes on
the top edge and both sides.
STEP 5: Connect gables to the modesty panel by lining up Blum connector screws
with the Blum connectors. Turn the screw on Blum Connector ¼ turn, do not over
tighten.
STEP 6: Place worksurface top face down on clean unobstructed area. Pick up
chassis assembly and line Blum connector screws to the exposed Blum Connectors
on the bottom of the surface. Turn the screw on Blum Connector ¼ turn, do not
over tighten.
STEP 7: Turn product upright. When fi nal position has been located, level the unit
with the levellers installed on both gables.
Required Tools
NOTE: Open and assemble only one product
at a time to avoid a potential mix-up of parts
and hardware.
It is adviseable to assemble the unit on a
carpet to avoid scratches.
L2DBxxxx L2DWxxxxxx
Safety Glasses Rubber Mallet Level Screwdriver #2 Phillips
Included Hardware
Blum Connector
(installed) L005650061
Assembly
Installation For Similar Products
Leveler
L007250037 “T” Nut Insert
L007250039 Blum Connector
Screw L005650060
FULL MODESTY WORKSURFACE
GABLE
GABLE