Global Contract Licence 2, Руководство по установке

Страница: 80 / 100

Page • globalcontract.com 79
• Fall 2017
GLOBAL
Contract
Ganging Worksurfaces
Any worksurface with a rectilinear edge may be ganged to another surface with a
rectilinear edge. There are two scenarios involved.
The fi rst involves taking an already existing (installed) table, and ganging it to
another, or several.
The second involves installing from the beginning. In either scenario, it is important
to note, use only leveling glides to create a ganging application.
Scenario #1
STEP 1: With table in upright position, loosen screws on (2) table legs to be used to
gang to adjacent surface, Rotate table leg around 45 degrees.
STEP 2: Place ganging surface up to existing table and position top above exposed
ganging plate of legs. Align screw positions and secure.
Scenario #2
STEP 1: Assemble primary table by installing (2) fi xed legs and (2) ganging legs ro-
tated at 45 degrees. (as per standard leg installation procedures with worksurfaces
on the fl oor upside down)
Invert table assembly exposing (2) legs with ganging plates
Assemble secondary table(s) by installing (2) remaining legs as per step 1 and
invert, position over primary table.
STEP 2: Place ganging surface up to existing table and position top above exposed
ganging plate of legs. Align screw positions and secure.
Repeat steps 1 through 2 to complete desired confi guration. Level accordingly.
ganging surfaces
2 ganging legs
old position new position
2 fi xed legs
loosen screws on (2) table
legs to be used to gang to
adjacent surface.
Note: Table is shortened
for instructional clarity.
Rotate centre legs 45 degrees so that leg base
assembles to both tables.
1
1
2
INSTALLATION GUIDELINES