Global Contract Licence 2, Руководство по установке

Страница: 62 / 100

Page • globalcontract.com 61
• Fall 2017
GLOBAL
Contract
INSTALLATION GUIDELINES
L2FDxxxxxx
Assembly
Required Tools
Safety Glasses Screwdriver #2 Robertson
Included Hardware
NOTE: Open and assemble only one product
at a time to avoid a potential mix-up of parts
and hardware.
It is adviseable to assemble the unit on a
carpet to avoid scratches.
L2FRxxxx L2FAxxxxL L2FPxxxxR L2TCWxxxxL/R
Left Hand Shown
Installation For Similar Products
STEP 1: Unpack and inspect individual pieces for damages or missing hardware.
STEP 2: Pick a clean unobstructed area to assemble desk. This unit is best to as-
semble upside down.
STEP 3: Place worksurface face down on clean unobstructed work area.
STEP 4: Place full monolegs as per product evenly spaced leaving overhang based
on shape of worksurface top and 4 “ from front and back edge. Secure using
#8x3/4 wood screws to secure to the bottom of the surface.
STEP 5: Place small monolegs at straight end. These legs should be placed 4”
from both back and side edges. Secure using #8x3/4 wood screws to secure to the
bottom of the surface. The short legs are shipped with a 5/16 bolt installed into the
bottom.
STEP 6: This product is shipped with a “HAT” channel support bar, install along
bottom of the surface. Please note that allow room to install Keyboard tray at users
edge if needed.
STEP 7: This product is intended to support from and be ganged to Licence 1 high
storage. To connect the small legs to Licence storage, Drill 3/8” through hole in
base storage and use bolt from inside storage to line up with nutsert in bottom of
the short leg.
Wood Screw #8 3/4
L007250032
WORKSURFACE
HAT CHANNEL
LLSQ3X3
MONOLEGS
LLSQ3X3H28