
Part No. 62401
Genie S-100 • S-105 • S-120 • S-125
7 - 124
Section 7 • Repair Procedures
First Edition • First Printing
AXLE COMPONENTS
Circle-end steer sensors:
8 At the platform controls, press the square-end
steer mode button.
9 Locate the steer sensor on top of the yoke pivot
pin.
10 Loosen the steer sensor cover retaining
fasteners. Do not remove them.
11 Rotate the steer sensor cover either clockwise
or counterclockwise. Measure the distance
between the inside of tire and the chassis side
plate on both sides of the axle.
12 Repeat step 4 until the tire is parallel with the
chassis.
13 Tighten the steer sensor cover fasteners.
14 Repeat steps 9 through 13 for the other circle-
end steer sensor.
13-2
Yoke and Hub
How to Remove the Yoke
and Hub
The yoke installation utilizes bushings and a thrust
washer that may require periodic replacement.
There is a steer sensor mounted to the upper yoke
pivot pin.
When removing a hose assembly
or fitting, the O-ring on the fitting
and/or hose end must be replaced
and then torqued to specification
during installation.
Refer to Section Two,
Hydraulic
Hose and Fitting Torque
Specifications.
1 Remove the hose hanger bracket retaining
fasteners mounted to the top of the yoke.
Remove the hose hanger bracket from the
machine.
2 Tag, disconnect and plug the hydraulic hoses
from the drive motor and brake assembly. Cap
the fittings on the drive motor and brake.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to squirt
or spray.
Содержание S-100
Страница 1: ......