Genie S-100, Руководство по обслуживанию, Страница: 360 / 497

Part No. 62401 Genie S-100 • S-105 • S-120 • S-125 7 - 8
Section 7 • Repair Procedures First Edition • First Printing
PLATFORM CONTROLS
Steer functions:
If the calibration fault is already
displayed at the ground box begin
with step 6.
1 Turn the key switch to the off position.
2 Press and hold the enter button on the
ground control panel while turning the key
switch to platform controls. Hold the enter
button for approximately 5 seconds.
3 Press the minus button twice, then press the
enter button twice.
4 Use the scroll button to scroll through the
menu until
RESET STEER JOYSTICK DEFAULTS
is
displayed. Press the button to select
YES
,
then press the button.
5 Exit programming mode.
To exit programming mode, use
the scroll button to scroll
through the menu until the
screen displays exit, then press
the plus button
once, change
the NO to YES, and press the
enter button
.
6 Do not start the engine.
7 Locate the drive/steer joystick.
8 Move the drive/steer joystick full stroke in the
left direction and hold for 5 seconds, then return
to the center or neutral position.
9 Move the drive/steer joystick full stroke in the
right direction and hold for 5 seconds, then
return to the center or neutral position.
Result: The alarm at the ground controls should
sound for a successful calibration.
Result: If the alarm does not sound, repeat the
calibration procedure, beginning with step 1.
Drive functions:
If the calibration fault is already
displayed at the ground box begin
with step 6.
1 Turn the key switch to the off position.
2 Press and hold the enter button on the
ground control panel while turning the key
switch to platform controls. Hold the enter
button for approximately 5 seconds.
3 Press the minus button twice, then press the
enter button twice.
4 Use the scroll button to scroll through the
menu until
RESET DRIVE JOYSTICK DEFAULTS
is
displayed. Press the button to select
YES
,
then press the button.
5 Exit programming mode.
To exit programming mode, use
the scroll button to scroll
through the menu until the
screen displays exit, then press
the plus button
once, change
the NO to YES, and press the
enter button
.
6 Do not start the engine.
7 Locate the drive/steer joystick.
8 Move the drive/steer joystick full stroke in the
forward direction and hold for 5 seconds, then
return to the center or neutral position.
9 Move the drive/steer joystick full stroke in the
reverse direction and hold for 5 seconds, then
return to the center or neutral position.
Result: The alarm at the ground controls should
sound for a successful calibration.
Result: If the alarm does not sound, repeat the
calibration procedure, beginning with step 1.
REV B