Part No. 62401
Genie S-100 • S-105 • S-120 • S-125
7 - 30
Section 7 • Repair Procedures
First Edition • First Printing
BOOM COMPONENTS
11 Remove the limit switch cover retaining
fasteners from the top of the number 2 boom
tube at the platform end of the machine.
Remove the limit switch cover.
12 Tag and disconnect the wiring connectors from
the proximity and limit switches on top of the
number 2 boom tube at the platform end of the
machine.
13 Remove the cable track roller guide mounting
fasteners from the ground controls side of the
machine at the platform end.
14 Remove the roller guide from the cable track
guide bracket at the engine side of the
machine.
15 Tag, disconnect and plug the hydraulic hoses
from the bottom of the bulkhead fittings on the
cable track support at the ground controls side
of the machine.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
16 Remove the bulkhead fitting locknuts from the
bulkhead fittings on the cable track support at
the ground controls side of the machine.
Remove and cap the fittings.
17 Tag and disconnect the wiring connectors.
The wiring connectors that need to
be disconnected are located next
to the hose fittings that were
removed in step 16.
If not removing the boom from the machine,
proceed to step 19.
18 Tag, disconnect and plug the primary extension
cylinder hydraulic hoses on the side of the
number 2 boom tube at the ground controls
side of the machine. Cap the fittings.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
19 Remove the cable track mounting fasteners
from the cable track support at the ground
controls side of the machine.
20 Remove the side panels from the boom cable
tube located under the cable track at the ground
controls side of the machine.
21 Remove the hose and cable cover mounting
fasteners from the pivot end of the boom at the
ground controls side of the machine. Remove
the cover.
22 Remove the hose and cable clamps from the
hoses and cables located below the boom pivot
on the inside of the turntable riser at the ground
controls side of the machine.
23 Tag and disconnect the electrical cables from
the cable track to the ground controls side of
the machine.
If not removing the boom from the machine,
proceed to step 25.
Содержание S-100
Страница 1: ......