GE LOGIQ 9, Техническое руководство

Страница: 342 / 570

GE M
EDICAL
S
YSTEMS
PROPRIETARY TO GE
D
IRECTION
2294854-100, R
EVISION
3 LOGIQ™ 9 P
ROPRIETARY
M
ANUAL
8-44 Section 8-7 - BEP MOD Replacement Procedure (BEP 2.x and above only)
8-7-5 MOD Drive Installation Procedure
Now reverse the removal procedure to install the new MOD. It cannot be stressed enough to use the
EXACT same screws to mount the new drive in the SAME position as they were removed.
If wrong screw, that is only slightly too long, is used to mount the MOD to the case the MOD will NOT
function.
1.) Refer to Figure 8-45 on page 8-42 and Figure 8-46 on page 8-43 , go through the side of the MOD
case to install the four screws mounting the MOD to the case.
2.) Attach the power and IDE Cables to the MOD. Refer to Figure 8-45 on page 8-42 .
3.) Install the four screws, two on each side, to attach the top cover and side rails from the MOD case.
NOTE: The side rails may need to be adjusted slightly so the MOD face is flush to the front of the BEP
when it is installed in the chassis.
4.) Slide the MOD into the front of the BEP as shown in Figure 8-42 on page 8-41 .
5.) Install the two screws in the front of the MOD drive as shown in Figure 8-42 on page 8-41 .
6.) Place the adhesive trim back on the BEP front face as shown in Figure 8-41 on page 8-40 .
7.) Install the one screw securing the side of the MOD to the rack as shown in Figure 8-40 on page 8-40
.
8.) Plug in the power connectors previously removed. Plug the IDE Cable into the CD-RW Drive and
the Motherboard. See Figure 8-43 on page 8-41 for reference. Pay attention to the orientation of
the guide pin on the IDE Cable connector and the missing pin on the IDE connection.
Figure 8-47 IDE Ribbon Connector
IDE Guide Pin