GE Medical Systems marquette Dash 2000, Руководство оператора, Страница: 58 / 272

2-8 Dash 2000 Patient Monitor Revision C
2005873-001
CAUTIONS
DISPOSABLES — Disposable devices are intended for single
use only. They should not be reused as performance could
degrade or contamination could occur.
DISPOSAL — At the end of its service life, the product
described in this manual, as well as its accessories, must be
disposed of in compliance with the guidelines regulating the
disposal of such products. If you have questions concerning
disposal of products, please contact GE Medical Systems
Information Technologies or its representatives.
ELECTROCAUTERY PRECAUTIONS — To prevent skin
burns, apply electrocautery electrodes as far as possible from
all other electrodes, a distance of at least 15 cm/6 in. is
recommended.
EMC — Magnetic and electrical fields are capable of
interfering with the proper performance of the device. For this
reason make sure that all external devices operated in the
vicinity of the monitor comply with the relevant EMC
requirements. X-ray equipment or MRI devices are a possible
source of interference as they may emit higher levels of
electromagnetic radiation. Also, keep cellular phones or other
telecommunication equipment away from the monitor.
INSTRUCTIONS FOR USE — For continued safe use of this
equipment, it is necessary that the listed instructions are
followed. However, instructions listed in this manual in no way
supersede established medical practices concerning patient
care.
LOSS OF DATA — Should the monitor at any time temporarily
lose patient data, the potential exists that active monitoring is
not being done. Close patient observation or alternate
monitoring devices should be used until monitor function is
restored.
If the monitor does not automatically resume operation within
60 seconds, power cycle the monitor using the power on/off
switch. Once monitoring is restored, you should verify correct
monitoring state and alarm function.
MAINTENANCE — Regular preventive maintenance should be
carried out annually (Technical Inspections). You are
responsible for any requirements specific to your country.