GE Medical Systems marquette Dash 2000, Руководство оператора, Страница: 31 / 272

Revision C Dash 2000 Patient Monitor 1-11
2005873-001
Control Keys
Power
Graph Go/Stop
On the right side of the monitor are five control keys. Their functions are
described below. Press the key to activate the function.
Beginning with the upper key and reading down, the keys are:
AC Battery
Power
Graph Go/Stop
NBP Go/Stop
Function
Silence Alarm
Trim Knob
Charging Status
ECG
150/ 50
75
SPO
2
105/ 90
RT
70
* * *
97
NBP
200/ 80
ADT
X
X X/
004
Location of Control Keys
The monitor will be powered at all times when plugged into AC power. This
key turns the monitoring function ON and OFF. When the monitor is
turned off, patient monitoring is discontinued; however, patient data
already accumulated is retained and the battery charging function
continues.
NOTES: To avoid unintentional switchoff, the POWER key must be pressed
at least 0.25 seconds to switch off the monitor.
In the event of a lockup, you can force a switch-off by pressing the
POWER key for five seconds.
Press this key once to start a graph run of the patient’s data. Press a second
time to stop. If pressed during an alarm graph run, the graph will run
continuously until GRAPH GO/STOP is pressed again. Note that an alarm
graph run is usually an automatic 20-second timed graph.
This key is also used to print a copy of non-real time screens. We refer to
these as information windows. Not all information windows can be printed.
If a printable information window is displayed, press GRAPH GO/STOP to
print a copy. If a nonprintable information window is displayed, pressing
the GRAPH GO/STOP key prints patient data as if the information window
was not displayed.