GE Medical Systems marquette Dash 2000, Руководство оператора, Страница: 106 / 272

5-10 Dash 2000 Patient Monitor Revision C
2005873-001
Recall Default
Here is some additional information regarding parameter priorities:
•
The first parameter cannot be changed. It must always be ECG.
•
If only four parameters are being monitored then the window will
occupy the four positions on the right side of the screen. These windows
are always the normal size windows. If monitoring more than four
parameters, some will occupy space at the bottom of the screen.
•
You can display a maximum of six parameters. The software will not
allow you to pick more parameters than can be displayed.
•
If you are not monitoring a designated parameter, the space is not left
blank, but filled with the next prioritized parameter. Should you begin
monitoring the designated parameter, the screen reconfigures so the
parameter occupies its designated space.
•
Whenever possible waveforms will align with their parameter window.
You can override waveform alignment with the WAVEFORMS ON/OFF
option.
The RECALL DEFAULT option is a direct action menu option used to
recall the monitor defaults
while monitoring an admitted patient.
In some cases you may have to temporarily override a default. For example,
it may be necessary to set different alarm limits for the needs of a specific
patient. The alarm limits you set are in effect until you change them again
or discharge the patient.
If you have made changes while monitoring a patient and then want to
recall the monitor defaults WITHOUT discharging the patient, use the
RECALL DEFAULT option.
NOTE: If you are actually changing Monitor Defaults, this option will not
recall any prior defaults. If you made changes to defaults that you
didn’t want to make you will have to change them manually. Refer
to your Defaults Worksheet at the front of this manual, or refer to
the Appendix, Factory Defaults, to see the factory defaults.