GE Medical Systems marquette Dash 2000, Руководство оператора, Страница: 49 / 272

Revision C Dash 2000 Patient Monitor 1-29
2005873-001
Putting the Monitor Into Operation
Monitor Installation
and Connection
WARNING
Before using the monitor for the first time, please read the
information given in chapter 2 ”Safety”.
The operating position does not influence the performance of the monitor in
any way.
•
Choose a location which affords an unobstructed view of the monitor
screen and easy access to the operating controls.
•
Set up the device in a location which affords sufficient ventilation. The
ventilation openings of the device must not be obstructed (by external
equipment, walls or blankets, for instance). The ambient conditions
specified in the Technical Specifications chapter must be ensured at all
times.
•
The Dash 2000 monitor is designed to comply with the requirements of
IEC 60601/EN 60601.
•
Using the power cord supplied with the monitor, connect it to the power
line (the illustration on page 1-3 shows the AC power connector). Use
only the original cord or an equivalent one.
WARNING
The Dash 2000 must be connected to a properly installed power
outlet with protective earth contacts only. If the installation
does not provide for a protective earth conductor, disconnect
the monitor from the power line and operate it on battery
power.
•
For measurements in or near the heart we recommend connecting the
monitor to the potential equalization system. Use the green and yellow
potential equalization cable and connect it to the pin labeled with the
symbol.
•
Our customer service engineers can be called in to connect the Dash
2000 to a central station and to the nurse call-system.
WARNING
For safety reasons, all connectors for patient cables and sensor
leads (with the exception of temperature) are designed to
prevent inadvertent disconnection, should someone pull on the
leads. Do not route cables in a way that they may present a
stumbling hazard. Do not install the monitor in a location
where it may drop on the patient. All consoles and brackets
used must have a raised edge at the front.