Page 5-20
MDE-4334C Atlas Start-up and Service Manual · April 2008
Pump Programming
Programming 8800 Series Units
To program Totals Input, proceed as follows:
1
Press
7
and then press
Enter
.
2
Select the Side (1 or 2) and then press
Enter
.
3
Select the Grade # and then press
Enter
.
4
Press
$ Total
.
5
Enter the money total and then press
Enter
.
Note: Repeat the above steps for the other side and grade.
6
Press
Volume Total
and repeat the above procedure for volume totals.
Command Code 8: Display Version Number
To display the Pump Controller Firmware Version, proceed as follows:
1
Enter
8
and then press
Enter
.
2
Select the Software Option and then press
Enter
, where:
1 = Pump Controller
3 = Customer Programmable Preset
Level 2 Programming
The following information gives specific programming steps for Level 2 commands. All this
information is entered on the Manager Keypad. Ensure that you follow the steps shown. The
side with the junction box opening is Side 1 while the other side is Side 2.
Note: * indicates the default value.
Pin Code Entry
You must enter Level 1 before accessing Level 2 commands.
•
Level 1
- Press
Fl
, enter the 4-digit ID (default 2222) and then press
Enter
.
•
Level 2
- From Level 1, enter any Level 2 Command Code (10-12), enter the 4-digit ID
(default 1503), and then press
Enter
. Press
F1
to exit any command code. Press
F2
to
return to normal operation.
Command Code 10: System Configuration
This multi-purpose code contains several sub codes called Function Codes (FC). Not all codes
are used for the Atlas. If accessible, do not change other codes from their default values or the
unit may not work properly.
1
Press
Enter
after making selections.
2
Press
10
.
3
Press
Function #
.