MDE-4334C Atlas Start-up and Service Manual · April 2008
Page 4-3
Performing Inspections
Preventive Maintenance and Inspection
Maintenance of Vendor Supplied Parts
Certain parts of the dispenser/pump are produced by vendors for Gasboy (hoses, nozzles, and
so on) and as such may have documentation different from the one that Gasboy supplies. In
these cases, it will be necessary to consult the vendor documentation for service intervals and
any adjustments, if required, for your dispenser/pump.
Use only Authorized Parts
The use of unauthorized parts can void your warranty, cause you to lose continuity of the
Underwriters Label on the pump, cause inefficient operation, and possibly an operational
hazard. Always use new gaskets and seals when servicing or rebuilding Gasboy Atlas
equipment.
Performing Inspections
This section provides instructions for scheduling two types of maintenance inspections:
• General inspections
• Component inspections
Safety Warnings
You are performing inspections and maintenance in a potentially dangerous environment of
flammable fuels/vapors and high voltage. Follow all safety precautions to prevent injury when
inspecting a pump/dispenser at the island.
WARNING
WARNING
You are performing inspection and maintenance in a potentially dangerous environment of
flammable fuels/vapors and high voltage.
Fire, explosion, or electrical shock could result in severe injury or death if you do not follow
safe procedures.
Read and obey all safety precautions in this manual to prevent potential injury or death.
General Inspections
Perform a general inspection of each pump/dispenser as follows:
• Every week, to verify if all pumps/dispensers are operating properly
• Whenever you receive a complaint about potential unit problems