MDE-4334C Atlas Start-up and Service Manual · April 2008
Page 5-15
Programming 8800 Series Units
Pump Programming
Manager Keypad Key Definitions and Use
Key(s)
Definition/Use
0-9
Numeric Values
F1
Function 1 – Used to start dispenser programming and sequence among programming and function
codes. In general, each depression of
F1
will take you back to a previous programming function
selection. Pressing
F1
from the normal dispenser state will always initiate the Programming mode.
Note that displays are always activated during the Programming mode.
F2
Function 2 – Used to exit programming mode and return to normal mode.
$Totals
Money Totals – Used to display money totals by side and grade. This key does not require a security
code.
Clear
is used to exit the Money Totals mode.
Vol. Total
Volume Totals – Used to display volume totals by side and grade. This key does not require a
security code.
Clear
key is used to exit the Volume Totals mode.
ENTER
Value entry keys – Sends the entered value to the pump.
CLEAR
Clear key – Used to clear the last keypad entry, and exit the Money and Volume Totals mode.
Programming Errors
The following table shows the currently allocated security and command codes that have been
assigned for Atlas. These codes can be modified by the user by the use of command codes.
Programming Level
Default Security Code
Level Primarily Used By
Level 1
2222
Level 2
1503
Level 3
1309
Display Conventions
The programming digit positions for the main money and volume displays are shown in
diagram below. This applies even in cases where more than six display digits are available for
display purposes. Information will be displayed on all grade PPUs when necessary and will be
restricted to digits 4 through 1, unless otherwise noted.
Figure 5-9: Location of Data on Displays at Power-up
Conversion Factor
US Gallons
Imperial Gallons
Liters
1012 Pulses per Gallon
Code
0
1
2
3
Memory Error
ROM Error
RAM Error
Sides
Single-sided
Dual-sided
Two Wire Pump ID 1-16
Pump Controller Software
Version#
ATLAS
90.xx
Code
1
2
Code
1
2
Unit Type
1 Grade
2 Grade
Code
0
1