______________________________________________________________
G1000 System Maintenance Manual
Page i
190-00903-00
Rev. A
This manual reflects the operation and configuration of GDU software version 9.00.
The following are general safety precautions that are not related to any specific procedure
and therefore do not appear elsewhere in this maintenance manual. These are
recommended precautions that personnel should understand and apply during the many
phases of maintenance and repair.
KEEP AWAY FROM LIVE CIRCUITS.
Maintenance personnel shall observe all
safety regulations at all times. Turn off system power before making or breaking
electrical connections. Regard any exposed connector, terminal board, or circuit board as
a possible shock hazard. Components which retain a charge shall be discharged only
when such grounding does not result in equipment damage. If a test connection to
energized equipment is required, make the test equipment ground connection before
probing the voltage or signal to be tested.
DO NOT SERVICE ALONE.
Personnel shall not under any circumstances reach into
or enter any enclosure for the purpose of servicing or adjusting the equipment without
immediate presence or assistance of another person capable of rendering aid.
INFORMATION SUBJECT TO EXPORT CONTROL LAWS
“This document may contain information which is subject to the Export Administration
Regulations (“EAR”) issued by the United States Department of Commerce (15 CFR,
Chapter VII Subchapter C) and which may not be exported, released or disclosed to
foreign nationals inside or outside the United States without first obtaining an export
license. The preceding statement is required to be included on any and all reproductions
in whole or in part of this manual.”